BAC-STOP NPE Free Dailymed
Generic: iodine is used for the treatment of Burns Dermatitis Herpetiformis Hypersensitivity Leg Ulcer Radiation Injuries Staphylococcal Infections Surgical Wound Infection Thyroid Diseases Vasculitis
Go PRO for all pill images
Active Ingredients :
Iodine..........................................................................0.50%
(Provides A Full .5% Available Iodine as used
Inert Ingredients
INERT INGREDIENTS:
Skin Conditioners............................................................2.00%
Other Inerts..................................................................95.50%
(Includes Iodine Stabilizers, Buffering Agents and Surfactants)
TOTAL:........................................................................100.00%
pH of 5.5 at time of manufacture
This product contains highly effective levels of
free iodine for fast kill of mastitis causing organisms.
General Recommendations
1. Use teat dip applicators made of plastic or other non-corrosive materials. Do not use cups made of aluminum.
2. When solution in the teat dip cup becomes dirty and/or noticeably loses color, discard remaining contents and refill cup with fresh teat dip.
3. Do not use this product for cleaning or sanitizing equipment.
4. Wash teat dip cups after each milking.
CAUTION: KEEP OUT OF REACH OF CHILDREN.
AVOID CONTACT WITH FOOD. DO NOT TAKE INTERNALLY.
First Aid Procedures
EYE CONTACT:IMMEDIATELY FLUSH EYE WITH LARGE AMOUNTS OF FRESH, TEPID WATER FOR 15 MINUTES. HOLD EYELID OPEN TO ENSURE COMPLETE IRRIGATION OF EYE AND LID TISSUES. TILT HEAD TO THE SIDE AND IRRIGATE THE EYE FROM THE BRIDGE OF THE NOSE TO THE OUTSIDE OF THE FACE.
SKIN CONTACT: FOR READY-TO-USE PRODUCTS, WASH ANY SENSITIVE AREAS.
INGESTIONS: DO NOT INDUCE VOMITING. NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON. DRINK LARGE AMOUNTS OF WATER. IF VOMITING OCCURS KEEP AIRWAYS OPEN. KEEP HEAD LOWER THAN THE HIPS TO PREVENT ASPIRATION INTO THE LUNGS.
ALWAYS SEEK IMMEDIATE MEDICAL ATTENTION
FOR MEDICAL EMERGENCIES CALL 1-800-424-9300
Recommended Procedures For Teat Sanitation
A. PRE-MILKING (PRE-DIPPING)
1. Remove visible soils from the teats.
2. Observe foremilk by stripping two or three streams of milk into a strip cup.
3. Dip, foam or spray the cow's teats full length with BAC-STOP NPE FREE Teat Dip.
4. Wait approximately 30 seconds.
5. Remove all teat dip by thoroughly drying the teats, teat orifices and udder (if foaming or spraying) with a clean, single service paper towel(s)
  to avoid contamination of milk.
6. Attach milking unit.
B. POST-MILKING (POST-DIPPING)
1. Immediately after milking, dip or spray all teats full length with BAC-STOP NPE FREE Teat Dip. Ensure good coverage of all sides of the teats and teat orifices.
UNIVERSITY TESTED AND PASSED USING
             NATIONAL MASTITIS COUNCIL PROTOCOLS
                    PROVEN EFFECTIVE IN REDUCING
                   NEW INTRAMAMMARY INFECTIONS.
Warning
DO NOT DILUTE THIS PRODUCT.
DO NOT RETURN TEAT DIP LEFT IN THE TEAT DIPPER TO STORAGE CONTAINER.
ENSURE THAT DIPPED TEATS ARE DRY BEFORE EXPOSING THE ANIMALS TO WEATHERÂ CONDITIONS WHICH MAY CAUSE DAMAGE TO THE TEATS.
PROTECT THIS PRODUCT FROM FREEZING.
  Not For Human Use
Bac-stop Npe Free
DISCLAIMER:
"This tool does not provide medical advice, and is for informational and educational purposes only, and is not a substitute for professional medical advice, treatment or diagnosis. Call your doctor to receive medical advice. If you think you may have a medical emergency, please dial 911."
"Do not rely on openFDA to make decisions regarding medical care. While we make every effort to ensure that data is accurate, you should assume all results are unvalidated. We may limit or otherwise restrict your access to the API in line with our Terms of Service."
"This product uses publicly available data from the U.S. National Library of Medicine (NLM), National Institutes of Health, Department of Health and Human Services; NLM is not responsible for the product and does not endorse or recommend this or any other product."
PillSync may earn a commission via links on our site