(c) 2024 PillSync.com

Generic: chlorhexidine gluconate and isopropyl alcohol is used for the treatment of Candidiasis, Oral Periodontal Diseases Skin Diseases, Infectious Gram-Negative Bacterial Infections Gram-Positive Bacterial Infections

Go PRO for all pill images

Active Ingredients


Chlorhexidine gluconate 3.15% w/v

Isopropyl alcohol 70% v/v

Purposes


Antiseptic

Antiseptic

Use


for the preparation of the patient's skin prior to surgery or injection

Warnings

  • For external use only
  • Flammable, keep away from fire or flame
  • Do not use with electrocautery procedures

Allergy alert


This product may cause a severe allergic reaction. Symptoms may include:
  • wheezing/difficulty breathing
  • shock
  • facial swelling
  • hives
  • rash

If an allergic reaction occurs, stop use and seek medical help right away.

Do not use

  • on patients allergic to chlorhexidine gluconate or any other ingredient in this product
  • for lumbar puncture or in contact with the meninges
  • on open skin wounds or as a general skin cleanser
  • under occlusive patch

When using this product


keep out of eyes, ears, mouth and mucous membranes. May cause serious or permanent injury if permitted to enter and remain.

If contact occurs, rinse with cold water right away and contact a doctor.

Stop use and ask a doctor if


irritation, sensitization, or allergic reaction occurs. These may be signs of a serious condition.

Keep out of reach of children.


If swallowed, get medical help or contact a Poison Control Center right away.

Directions

  • use with care in premature infants or infants under 2 months of age. These products may cause irritation or chemical burns.
  • maximum treatment area for one maxi swabstick is approximately: dry site: 4 by 4 inches (10 by 10 cm) or moist site: 3 by 5 inches (7.5 by 12.5 cm)
  • tear open the pouch to expose the swabstick
  • remove the swabstick from package. Do not touch the foam tip.
  • prior to surgery or injection, apply one flat side of foam tip to the proposed skin site and prep the skin in vigorous back-and-forth repeated strokes, turning the swabstick over (unused side of the foam tip) half way in the procedure
  • dry site: scrub repeatedly back and forth for 15 seconds with each side of the applicator for a total of 30 seconds. Allow to air dry for approximately 30 seconds.
  • moist site: scrub repeatedly back and forth for 1 minute with each side of the applicator for a total of 2 minutes. Allow to air dry for approximately 1.5 minutes.
  • do not blot or wipe dry
  • discard after a single use

Other Information

  • store between 68-77°F (20-25°C)
  • avoid freezing and excessive heat above 104°F (40°C)
  • for hospital and professional use only

Inactive Ingredients


USP purified water

Package/label Principal Display Panel


Packet Label



Box Label



Packet (bulk)





Insert





DISCLAIMER:

"This tool does not provide medical advice, and is for informational and educational purposes only, and is not a substitute for professional medical advice, treatment or diagnosis. Call your doctor to receive medical advice. If you think you may have a medical emergency, please dial 911."

"Do not rely on openFDA to make decisions regarding medical care. While we make every effort to ensure that data is accurate, you should assume all results are unvalidated. We may limit or otherwise restrict your access to the API in line with our Terms of Service."

"This product uses publicly available data from the U.S. National Library of Medicine (NLM), National Institutes of Health, Department of Health and Human Services; NLM is not responsible for the product and does not endorse or recommend this or any other product."

PillSync may earn a commission via links on our site